Refer to the exhibit. An SPA service connection is experiencing connectivity problems. Which configuration setting should the administrator verify and correct first? (Choose one answer)

A. Remote Gateway
B. BGP Peer IP
C. Network overlay ID
D. Authentication Method

Correct Answer: B

Brave-Dump Clients Votes

B 100%

Comments

Brave-Dumps Admin 2025-10-30 14:04:42

Selected Answers: B

it needs additional check

javaughn Bryan 2025-11-21 20:29:39

Selected Answers: B

Given that the IPsec tunnel to the San Jose POP is successfully established—as confirmed by its "Up" status—the fundamental tunnel parameters like the Remote Gateway, Network Overlay ID, and Authentication Method can be ruled out as the primary cause, as a misconfiguration in any of these would have prevented the tunnel from forming altogether.

Therefore, the connectivity problem with the SPA service must exist at the routing layer, which operates over the secure tunnel. Since BGP is the protocol responsible for dynamically exchanging routes, the BGP peering session becomes the most probable point of failure. Consequently, the administrator should first verify and correct the BGP Peer IP configuration, as an issue here would explain why the tunnel is active, but application traffic cannot be properly routed, leading to the service disruption.

ANSWER: B