View all questions & answers for the FCSS - Network Security 7.4 Support Engineer Exam Materials exam


FCSS - Network Security 7.4 Support Engineer Exam Materials-Question 57 Discussion

Refer to the exhibit, which contains the partial configuration of an IPsec VPN configuration. After reviewing the configuration, what can you conclude about the IPsec VPN Phase 1 setup? (Choose one answer)

  • A. The tunnel is configured as a route-based VPN.
  • B. The VPN is configured with DHCP over IPsec.
  • C. Dead Peer Detection is disabled.
  • D. The VPN is configured using IKEv2.
Correct Answer: B

Brave-Dump Clients Votes

B 100%

Comments



Brave-Dumps.com Admin 2025-05-14 15:36:09

Selected Answers: B


The settings set type dynamic, along with set ipv4-start-ip and set ipv4-end-ip, indicate that the IPsec VPN is configured for dial-up remote access clients. These clients do not have fixed IPs and instead receive their configuration dynamically - such as IP addresses, subnet mask, and DNS - via mode-cfg, which functions similarly to DHCP over IPsec.